Paradigm shifts for total safety

Paradigm shifts for Total Safety

I would like to reproduce the philosophy of E. Scott Geller on the subject as it is important to understand by safety practitioners then by anyone else in the organisation.

The three new Es - Ergonomics, Empowerment, and Evaluation over the  old ones - Engineering, Enforcement, and Education are modern shifts in safety when one want to go beyond current safety performance and reach new heights in safety excellence. It does not meant that one should abandon old ones but think beyond these in order to prevent injuries.

these will be explained further in next blog. 

Comments

Post a Comment

Popular posts from this blog

@safetitude: 6-Steps Total Safety Culture Model

Image
@safetitude: 6-Steps Total Safety Culture Model Further, an extension to 2 earlier posts that intended to enhance Safety performance and to build and establish a Total Safety Culture (TSC), this is one proprietary designed model as a guide to the journey. The strategy can be started with a small model with a selection of a change agent ( a worker with right safety attitude and zealous to take forward) and making him work through various stages of the model. Once one cycle is established, this can be repeated on the bigger scale until every worker in a business unit is covered. This also can be extended to higher management members in a later phase of implementation.
Read more
Safetitude Training And Consultancy LLP, based at Nagpur, India is now poised to help industries aiming to excel with HSEF performance. A commitment of ours at core " Help Industry gain through Safety" is here that make them realize "Safety Pays- in all way" including profitability. The various programs are designed to address the root cause of a lagging Safety in the organization. Our programs influence workers to imbibe and nurture attitude for safety that is Safetitude. Once it gets institutionalized, every one tends to value it through adhering Safety in auto-controlled mode. A culture for pro safety behavior, of course is not possible without buy-in commitment by those who has control over every affairs of the business. Let's understand, Safety is a function of Industry like many other e.g. production, cost, quality etc. So, let ambitious organization try us for value addition to their businesses. May reach out to us at knowsafety@safetitude.com #safety   #
Read more
Image
                                                     S A F E T I T U D E Arc Flash Boundary (AFB) Electrical related accidents are most severest one owing to its invincible and fatal-result characteristics. The extensive use of electricity almost everywhere as risk-escalating factor makes the things even worse. It is important to know that working on live low voltage (220V) installation is not alone dangerous but also working near live energized one is equally risky. Therefore, an understanding of Arc Flash Boundary becomes of prime importance. The following brief knowledge help you understand about AFB An energy exposure of 1.2 calories per centimeter squared (Cal/cm2) is the widely accepted incident energy value considered to be where the onset of a second-degree burn could occur. The AFB must be determined as part of an arc flash risk assessment and a requirement for arc flash labels. It can be calculated using an equation defined by IEEE 1584—IEEE Guide for Performing Arc Flash Haz
Read more